Lexus NX: Amplifier Antenna
READ NEXT:
Components
COMPONENTS ILLUSTRATION *A w/ Power Back Door *B w/o Power Back Door *1 BACK DOOR CENTER GARNISH *2 BACK DOOR FINISH COVER LH *3 BACK DOOR FINISH COVER RH *4 BACK DOOR LO
Removal
REMOVAL PROCEDURE 1. REMOVE BACK DOOR CENTER GARNISH Click here 2. REMOVE BACK DOOR SIDE GARNISH LH Click here 3. REMOVE BACK DOOR SIDE GARNISH RH Click here 4. REMOVE BACK DOOR TRIM BASE (w/
Installation
INSTALLATION PROCEDURE 1. INSTALL NO. 1 AMPLIFIER ANTENNA ASSEMBLY (a) Attach the guide and install the No. 1 amplifier antenna assembly with the bolt. Torque: 8.3 N·m {85 kgf·cm, 73 in·lbf} (b) C
SEE MORE:
Low Output Signal of Front Speed Sensor RH (C1271,C1272,C1464,C1465)
DESCRIPTION Each speed sensor detects the wheel speed and sends the signals to the skid control ECU (brake booster with master cylinder assembly). These signals are used for ABS control. DTCs C1271 and C1272 are cleared when the speed sensor sends a wheel speed signal or when Test Mode ends. DTCs C1
Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure described below is for the LH side.
PROCEDURE 1. REMOVE CENTER BACK DOOR GARNISH Click here 2. REMOVE BACK DOOR SIDE GARNISH LH Click here 3. REMOVE BACK DOOR SIDE GARNISH RH Click here
© 2016-2025 Copyright www.lexunx.com
