Lexus NX: Back Door Lock
READ NEXT:
Components
COMPONENTS ILLUSTRATION *A w/o Power Back Door *B w/ Power Back Door *1 BACK DOOR FINISH COVER LH *2 BACK DOOR FINISH COVER RH *3 BACK DOOR CENTER GARNISH *4 BACK DOOR LO
Removal
REMOVAL PROCEDURE 1. REMOVE BACK DOOR CENTER GARNISH Click here 2. REMOVE BACK DOOR SIDE GARNISH LH Click here 3. REMOVE BACK DOOR SIDE GARNISH RH HINT: Use the same procedure described for the LH
Inspection
INSPECTION PROCEDURE 1. INSPECT BACK DOOR LOCK ASSEMBLY (w/o Power Back Door) (a) Check the operation of the door lock motor. (1) Move the back door lock assembly to the lock position. (2) Apply au
SEE MORE:
Dcm Operation History
DCM OPERATION HISTORY HINT:
This function shows the telematics network status when the DCM (telematics transceiver) was operated. Use this when no DTC is present but this telematics system was unable to connect to the call center. This symptom may occur if cell phone signal strength is very weak.
Dtc Check / Clear
DTC CHECK / CLEAR CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the power switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Front Radar Sensor / Trouble Codes. Body Electrical > Front Radar Sensor > Trouble Codes (e) Check for DTCs (Test
© 2016-2025 Copyright www.lexunx.com
