Lexus NX: Camshaft

READ NEXT:

 Components

COMPONENTS ILLUSTRATION *1 AIR CLEANER CAP SUB-ASSEMBLY *2 AIR CLEANER CASE SUB-ASSEMBLY *3 AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY *4 ENGINE WIRE *5 FAN AND GENERATOR V BELT

 Removal

REMOVAL PROCEDURE 1. REMOVE SERVICE PLUG GRIP Click here 2. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY Click here 3. REMOVE REAR ENGINE UNDER COVER RH Click here 4. REMOVE FAN AND GENERATOR V B

 Cylinder Block

SEE MORE:

 Problem Symptoms Table

PROBLEM SYMPTOMS TABLE NOTICE: If the headlight ECU sub-assembly LH has been replaced, it is necessary to synchronize the vehicle information and initialize the headlight ECU sub-assembly LH. Click here HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspecte

 Installation

INSTALLATION PROCEDURE 1. INSTALL BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY (a) Attach the 12 clips to install the back door outside garnish sub-assembly. (b) Install the 4 bolts. Torque: 5.0 N·m {51 kgf·cm, 44 in·lbf} 2. INSTALL BACK DOOR TRIM BOARD ASSEMBLY Click here 3. INSTALL

© 2016-2026 Copyright www.lexunx.com