Lexus NX: Components
COMPONENTS
ILLUSTRATION
| *1 | CRUISE CONTROL MAIN SWITCH | *2 | STEERING PAD SWITCH ASSEMBLY |
READ NEXT:
Removal
REMOVAL PROCEDURE 1. REMOVE STEERING PAD Click here 2. REMOVE CRUISE CONTROL MAIN SWITCH Click here 3. REMOVE STEERING PAD SWITCH ASSEMBLY (a) Disconnect the connector from the spiral cable w
Inspection
INSPECTION PROCEDURE 1. INSPECT STEERING PAD SWITCH ASSEMBLY (a) Measure the resistance according to the value(s) in the table below. *A w/ Lane Departure Alert System - - *1 SEEK+ *
Installation
INSTALLATION PROCEDURE 1. INSTALL STEERING PAD SWITCH ASSEMBLY (a) Engage the 4 claws and 3 guide pins to install the steering pad switch assembly to the steering wheel sub-assembly. (b) Install the 2
SEE MORE:
Stop Switch Circuit Malfunction (C164E)
DESCRIPTION When a stop light switch assembly circuit malfunction signal sent from the electronically controlled brake system is detected by the clearance warning ECU assembly, DTC C164E is stored. DTC No. Detection Item DTC Detection Condition Trouble Area C164E Stop Switch Circuit M
Disassembly
DISASSEMBLY CAUTION / NOTICE / HINT NOTICE:
When using a vise, place aluminum plates between the part and vise.
When using a vise, do not overtighten it.
HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. DISCONNECT REAR
© 2016-2026 Copyright www.lexunx.com
