Lexus NX: Components

COMPONENTS

ILLUSTRATION

*1

DECK FLOOR BOX LH

*2

NO. 3 DECK BOARD SUB-ASSEMBLY

*3

REAR DECK FLOOR BOX

*4

NEGATIVE AUXILIARY BATTERY TERMINAL

N*m (kgf*cm, ft.*lbf): Specified torque

-

-

ILLUSTRATION

*1

ABSORBER CONTROL ECU

*2

CONNECTOR

N*m (kgf*cm, ft.*lbf): Specified torque

-

-

READ NEXT:

 Removal

REMOVAL CAUTION / NOTICE / HINT NOTICE: While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or any door cour

 Installation

INSTALLATION PROCEDURE 1. INSTALL ABSORBER CONTROL ECU (a) Install the absorber control ECU with the 2 bolts. Torque: 8.5 N·m {87 kgf·cm, 75 in·lbf} NOTICE: Avoid any impact to the absorber con

 Tire / Wheel

SEE MORE:

 Terminals Of Ecu

TERMINALS OF ECU CHECK MULTIPLEX NETWORK DOOR ECU (a) Disconnect the Y26 and Y27 multiplex network door ECU connectors. (b) Measure the voltage and resistance according to the value(s) in the table below. HINT: Measure the values on the wire harness side with the connector disconnected. Terminal

 Blind Spot Monitor Slave Module Beam Axis Inspection Incomplete (C1ABC)

DESCRIPTION This DTC is stored when a beam axis inspection has not been performed for the blind spot monitor sensor RH. HINT: This DTC is always stored after replacing a blind spot monitor sensor. The purpose of this DTC is to ensure that beam axis inspection is performed. Completing the beam axis i

© 2016-2025 Copyright www.lexunx.com