Lexus NX: Components

COMPONENTS

ILLUSTRATION

*1

INSTRUMENT SIDE PANEL LH

*2

NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

*3

TRIP SWITCH (LIGHT CONTROL RHEOSTAT)

-

-

READ NEXT:

 Removal

REMOVAL PROCEDURE 1. REMOVE INSTRUMENT SIDE PANEL LH Click here 2. REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY Click here 3. REMOVE TRIP SWITCH (LIGHT CONTROL RHEOSTAT) (a) Using

 Inspection

INSPECTION PROCEDURE 1. INSPECT TRIP SWITCH (LIGHT CONTROL RHEOSTAT) *1 Up Switch *2 Down Switch *a Component without harness connected (Trip Switch (Light Control Rheostat)) (a)

 Installation

INSTALLATION PROCEDURE 1. INSTALL TRIP SWITCH (LIGHT CONTROL RHEOSTAT) (a) Attach the 2 claws to install the trip switch (light control rheostat). 2. INSTALL NO. 1 INSTRUMENT PANEL SAFE

SEE MORE:

 Yaw Rate Sensor (C1234,C1243-C1245,C1279)

DESCRIPTION The skid control ECU (brake booster with master cylinder assembly) receives signals from the yaw rate and acceleration sensor (airbag ECU assembly) via CAN communication. The airbag ECU assembly has a built-in yaw rate and acceleration sensor and detects the vehicle condition using 2 cir

 Installation

INSTALLATION PROCEDURE 1. PRECAUTION CAUTION: Be sure to read precaution thoroughly before servicing. Click here 2. INSTALL REAR TIRE PRESSURE MONITOR INITIATOR (a) Install the rear tire pressure monitor initiator with the 2 nuts. Torque: 8.3 N·m {85 kgf·cm, 73 in·lbf} (b) Connect the grommet.

© 2016-2025 Copyright www.lexunx.com