Lexus NX: Customize Parameters
CUSTOMIZE PARAMETERS
CUSTOMIZE ROAD SIGN ASSIST SYSTEM
NOTICE:
Be sure to make a note of the current settings before customizing.
(a) Customizing with the multi-information display
(1) Turn the power switch on (IG).
(2) Using the steering pad switches, change the customize settings.
HINT:
Each item is displayed on the "Setting" screen of the multi-information display.
Road Sign Assist Setup| Display | Description | Setting | Default | Relevant ECU | |
|---|---|---|---|---|---|
| RSA | Road sign assist function setting | ON / OFF | ON | Forward recognition camera | |
| Notification Method | Above Speed Limit | Excess speed notification method setting | No Notification / Only Visual / Visual & Audio | Only Visual | Forward recognition camera |
| Overtaking | Overtaking prohibition notification method setting | No Notification / Only Visual / Visual & Audio | Only Visual | Forward recognition camera | |
| Others | Other notification method setting | No Notification / Only Visual / Visual & Audio | Only Visual | Forward recognition camera | |
| Notification Level | Excess speed notification level setting | 10 km/h (5 MPH) / 5 km/h (3 MPH) / 2 km/h (1 MPH) | 2 km/h (1 MPH) | Forward recognition camera | |
READ NEXT:
Utility
UTILITY NOTICE: If the forward recognition camera has been replaced due to a malfunction in the road sign assist system, be sure to perform forward recognition camera adjustment. Otherwise all systems
Terminals Of Ecu
TERMINALS OF ECU NOTICE:
DTCs may be output when connectors are disconnected during inspection. Therefore, be sure to clear the DTCs using the Techstream once the inspection has been completed.
D
Diagnosis System
DIAGNOSIS SYSTEM DIAGNOSIS FUNCTION (a) The road sign assist system displays a warning message on the multi-information display to inform the driver that the system is unavailable when it is malfuncti
SEE MORE:
Removal
REMOVAL PROCEDURE 1. REMOVE REAR SEAT ASSEMBLY (a) for Manual Seat: Click here (b) for Power Seat: Click here 2. REMOVE REAR FLOOR FINISH PLATE Click here 3. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH Click here 4. REMOVE UPPER DECK TRIM SIDE BOARD RH Click here 5. REMOVE ROPE HOO
Utility
UTILITY CANCEL COMMUNICATION FUNCTION PAUSING HINT: This function is used to cancel communication function pausing mode (a) Connect the Techstream to the DLC3. (b) Turn the power switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Telematics / Utility / Cance
