Lexus NX: Customize Parameters
CUSTOMIZE PARAMETERS
CUSTOMIZE FRONT POWER SEAT CONTROL SYSTEM (w/ Memory)
HINT:
The following items can be customized.
NOTICE:
- When the customer requests a change in a function, first make sure that the function can be customized.
- Record the current settings before customizing.
(a) Customizing with the Techstream
(1) Connect the Techstream to the DLC3.
(2) Turn the power switch on (IG).
(3) Turn the Techstream on.
(4) Enter the following menus: Customize Setting / Entry & Start or Seat.
(5) Select the setting by referring to the table below.
Entry & Start| Tester Display | Description | Default | Setting | ECU |
|---|---|---|---|---|
| Seat position/Tilt & Telesco memory recall setting | This customize function switches the condition of the seat position and tilt & telescopic memory recall. Possible recall activation parameter "D-door unlock and open by smart system" or "Any door unlock and open with smart system". | D Door | 0:D Door,1:Any Door | Main body ECU (Multiplex network body ECU) |
| Tester Display | Description | Default | Setting | ECU |
|---|---|---|---|---|
| Seat Move Distance | Allows customizing of the seat movement distance for the power easy access system. | Standard | 00:OFF,01:Little,10:Standard | Main body ECU (Multiplex network body ECU) |
(b) Customizing with the multi-display
(1) Turn the power switch on (IG).
(2) Enter the following menus: MENU / Setup / Vehicle / Vehicle settings / Vehicle customization / Other vehicle settings.
(3) Select the setting by referring to the table below.
| Display | Description | Default | Setting | Relevant ECU |
|---|---|---|---|---|
| Driver's seat easy exit | Allows customizing of the seat movement distance for the power easy access system. | Full | Off / Partial / Full | Main body ECU (Multiplex network body ECU) |
READ NEXT:
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of
Terminals Of Ecu
TERMINALS OF ECU CHECK FRONT POWER SEAT SWITCH LH (a) Disconnect the g11 and g12 front power seat switch LH connectors. (b) Measure the voltage and resistance according to the value(s) in the table b
Diagnosis System
DIAGNOSIS SYSTEM DESCRIPTION (a) Front power seat control system (w/ Memory) data and Diagnostic Trouble Codes (DTCs) can be read through the Data Link Connector 3 (DLC3) of the vehicle. When the syst
SEE MORE:
Pointer not Displayed on Screen or Pointer does not Move
CAUTION / NOTICE / HINT NOTICE: When replacing the radio receiver assembly, always replace it with a new one. If a radio receiver assembly which was installed to another vehicle is used, the following may occur:
A communication malfunction DTC may be stored.
The radio receiver assembly may not
Terminals Of Ecu
TERMINALS OF ECU *a Component with harness connected (Power Steering ECU Assembly) - - CHECK POWER STEERING ECU ASSEMBLY (a) Measure the voltage and resistance according to the value(s) in the table below. NOTICE: When the power steering warning light (red) is illuminated due to a malfu
