Lexus NX: Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
Pre-collision System| DTC No. | Detection Item | Link |
|---|---|---|
| C142571 | Stop Light Relay Actuator Stuck | |
| U012587 | Lost Communication With Multi-axis Acceleration Sensor Module Missing Message | |
| U012687 | Lost Communication with Steering Angle Sensor Module Missing Message | |
| U012987 | Lost Communication with Brake System Control Module Missing Message | |
| U023587 | Lost Communication with Cruise Control Front Distance Range Sensor Missing Message | |
| U023A87 | Lost Communication with Image Processing Module "A" | |
| U029387 | Lost Communication with Hybrid Powertrain Control Module Missing Message | |
| U030051 | Internal Control Module Software Incompatibility Not Programmed | |
| U030057 | Internal Control Module Software Incompatibility Invalid / Incompatible Software Component | |
| U041881 | Invalid Data Received from Brake System Control Module Invalid Serial Data Received | |
.gif)
READ NEXT:
Vehicle Control History
VEHICLE CONTROL HISTORY NOTICE: When checking the vehicle control history, make sure to record the output histories. Then, remove the histories and recheck the output histories again. CHECK VEHICLE CO
Stop Light Relay Actuator Stuck (C142571)
DESCRIPTION The stop light switch assembly and skid control ECU (brake booster with master cylinder assembly) outputs stop light signals. When the skid control ECU (brake booster with master cylinder
Lost Communication With Multi-axis Acceleration Sensor Module Missing Message (U012587,U012687,U012987,U029387)
DESCRIPTION DTC No. Detection Item DTC Detection Condition Trouble Area U012587 Lost Communication With Multi-axis Acceleration Sensor Module Missing Message While the vehicle is bein
SEE MORE:
System Description
SYSTEM DESCRIPTION CAN COMMUNICATION SYSTEM (a) The blind spot monitor system uses CAN communication to transmit data between the right and left blind spot monitor sensors and each ECU. (b) If there is a problem in the CAN communication, the right and left blind spot monitor sensors output a CAN com
Sub Radiator
RemovalREMOVAL PROCEDURE 1. REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY Click here 2. DRAIN COOLANT (for Inverter Coolant) Click here 3. REMOVE UPPER RADIATOR SUPPORT SUB-ASSEMBLY Click here 4. REMOVE NO. 2 FAN SHROUD Click here 5. REMOVE RADIATOR ASSEMBLY (for Inverter Coolant) (a) Slide
