Lexus NX: How To Proceed With Troubleshooting

CAUTION / NOTICE / HINT

HINT:

  • Use the following procedure to troubleshoot the LEXUS ENFORM system.
  • *: Use the Techstream.

PROCEDURE

1.

VEHICLE BROUGHT TO WORKSHOP

NEXT

2.

CHECK THE CUSTOMER'S CONTRACT STATUS

(a) Check if the satellite radio and LEXUS ENFORM contracts are valid, or if the contract period has ended using the vehicle inquiry function on TIS.

Result

Proceed to

Both Contracts are valid.

A

Contract for satellite radio is not valid.

B

Contract for LEXUS ENFORM is not valid.

C

B

GO TO NAVIGATION SYSTEM

C

GO TO SAFETY CONNECT SYSTEM

A

3.

CHECK CAN COMMUNICATION SYSTEM

(a) Check if CAN communication system DTCs are output.

Click here

Result

Proceed to

CAN DTCs are not output.

A

CAN DTCs are output.

B

B

GO TO CAN COMMUNICATION SYSTEM

A

4.

CHECK DTC*

(a) Check for DTCs.

Safety connect system: Click here

Telematics system: Click here

Body Electrical > Telematics > Trouble Codes

Result

Proceed to

DTCs are not output.

A

Safety connect system DTCs are output.

B

Telematics system DTCs are output.

C

B

GO TO SAFETY CONNECT SYSTEM

C

GO TO TELEMATICS SYSTEM

A

5.

PROBLEM SYMPTOMS TABLE

(a) Refer to Problem Symptoms Table.

Click here

Result

Proceed to

Fault is not listed in Problem Symptoms Table.

A

Fault is listed in Problem Symptoms Table.

B

HINT:

If the symptom does not recur and no DTCs are output, perform the simulation method.

Click here

B

GO TO STEP 7

A

6.

PERFORM TROUBLESHOOTING

(a) Refer to Terminals of ECU.

Click here

NEXT

7.

REPAIR OR REPLACE

NEXT

8.

CONFIRMATION TEST

NEXT

END

READ NEXT:

 Operation Check

OPERATION CHECK NOTICE: When using both Fleet Apps and Infotainment Apps together at the same time, it is not possible to remove only one type of app. By using "Delete all personal data from the head

 Problem Symptoms Table

PROBLEM SYMPTOMS TABLE NOTICE: After replacing the radio receiver assembly of vehicles subscribed to pay-type satellite radio broadcasts, registration of the XM radio ID is necessary (w/ SXM System

 Terminals Of Ecu

TERMINALS OF ECU DCM (TELEMATICS TRANSCEIVER) Click here RADIO RECEIVER ASSEMBLY Click here NAVIGATION ECU Click here

SEE MORE:

 Vehicle Control History

VEHICLE CONTROL HISTORY NOTICE: When checking the Vehicle Control History, make sure to record the output codes. Then, clear the Vehicle Control History (RoB) and check it again. CHECK VEHICLE CONTROL HISTORY (FRONT RADAR SENSOR SYSTEM) (a) Connect the Techstream to the DLC3. (b) Turn the power swit

 Sliding Roof does not Move by Operating Sliding Roof Control Switch

DESCRIPTION The sliding roof drive gear sub-assembly (sliding roof ECU) receives each signal when the map light assembly (slide roof switch) is operated and drives its built-in motor. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Inspect the fuses for circuits related to this system before perf

© 2016-2025 Copyright www.lexunx.com