Lexus NX: Intrusion Sensor
READ NEXT:
Precaution
PRECAUTION PRECAUTIONS DURING REPLACEMENT NOTICE: When replacing electronic parts, if there is a possibility that your body may contact a circuit board, etc., use the recommended tools and observe all
Components
COMPONENTS ILLUSTRATION *1 DECK FLOOR BOX LH *2 NO. 3 DECK BOARD SUB-ASSEMBLY *3 REAR DECK FLOOR BOX *4 NEGATIVE AUXILIARY BATTERY TERMINAL N*m (kgf*cm, ft.*lbf): Specified
Removal
REMOVAL PROCEDURE 1. REMOVE DECK BOARD ASSEMBLY Click here 2. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY Click here 3. REMOVE REAR DECK FLOOR BOX (w/ Spare Tire) Click here 4. REMOVE DECK FLOOR BOX LH
SEE MORE:
Components
COMPONENTS ILLUSTRATION *1 CLEARANCE LIGHT ASSEMBLY LH *2 CLEARANCE LIGHT ASSEMBLY RH *3 FRONT BUMPER GUARD ASSEMBLY *4 HOOD TO FRONT END PANEL SEAL *5 NO. 3 ENGINE ROOM WIRE *6 RADIATOR GRILLE SUB-ASSEMBLY *7 OUTSIDE MOULDING RETAINER - - ILLUSTRATION
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. INSTALL FRONT POWER SEAT SWITCH LH (a) Install the front power seat switch LH with the 3 screws. 2. INSTALL FRONT SEAT CUSHION SHIELD LH Clic
© 2016-2026 Copyright www.lexunx.com
