Lexus NX: Lost Communication with Brake System Control Module (U0129,U0140,U0293)
DESCRIPTION
These DTCs are stored when the CAN communication system is malfunctioning.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U0129 | Lost Communication with Brake System Control Module | The vehicle approaching speaker controller does not receive data from the skid control ECU (brake booster with master cylinder assembly) for approximately 10 seconds or more. |
|
| U0140 | Lost Communication with Body Control Module | The vehicle approaching speaker controller does not receive data from the main body ECU (multiplex network body ECU) for approximately 10 seconds or more. |
|
| U0293 | Lost Communication with Hybrid/EV Powertrain Control Module | The vehicle approaching speaker controller does not receive data from the hybrid vehicle control ECU for approximately 10 seconds or more. |
|
PROCEDURE
| 1. | CHECK FOR DTC |
(a) Connect the GTS to the DLC3.
(b) Turn the power switch on (IG).
(c) Turn the GTS on.
(d) Enter the following menus: Body Electrical / Vehicle Proximity Notification System / Trouble Codes.
(e) Check for DTCs.
Body Electrical > Vehicle Proximity Notification System > Trouble CodesHINT:
When DTCs indicating a CAN communication system malfunction are output, perform troubleshooting for the CAN communication system before the vehicle proximity notification system.
| NEXT | .gif) | GO TO CAN COMMUNICATION SYSTEM |
READ NEXT:
There is No Sound Made
DESCRIPTION Based on signals received from each ECU, the vehicle approaching speaker controller outputs warning sounds through the vehicle approaching speaker assembly. WIRING DIAGRAM CAUTION / NOTIC
Vehicle Approaching Speaker
ComponentsCOMPONENTS ILLUSTRATION *1 RADIATOR SUPPORT OPENING COVER *2 VEHICLE APPROACHING SPEAKER ASSEMBLY N*m (kgf*cm, ft.*lbf): Specified torque - - RemovalREMOVAL PROCEDU
SEE MORE:
Initialization
INITIALIZATION INITIALIZE PARKING ASSIST MONITOR SYSTEM (a) When the "!" mark is displayed on the multi-display assembly, correct the steering angle neutral point using the following method. (1) Fully turn the steering wheel to the right and left on flat ground. NOTICE: Memorizing the steering angle
Fuel Sender Gauge Assembly
ComponentsCOMPONENTS ILLUSTRATION *1 FUEL SENDER GAUGE ASSEMBLY - - N*m (kgf*cm, ft.*lbf): Specified torque - - RemovalREMOVAL PROCEDURE 1. REMOVE FUEL TANK ASSEMBLY Click here 2. REMOVE FUEL SENDER GAUGE ASSEMBLY (a) Remove the 5 screws and fuel sender gauge assembly
