Lexus NX: Multiplex Tilt And Telescopic Ecu
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 DECK FLOOR BOX LH *2 REAR DECK FLOOR BOX *3 NO. 3 DECK BOARD SUB-ASSEMBLY *4 NEGATIVE AUXILIARY BATTERY TERMINAL N*m (kgf*cm, ft.*lbf): Specified
Installation
INSTALLATION PROCEDURE 1. INSTALL MULTIPLEX TILT AND TELESCOPIC ECU (a) Attach the claw and install the multiplex tilt and telescopic ECU to the bracket. (b) Install the bolt and multiplex tilt and te
Removal
REMOVAL PROCEDURE 1. PRECAUTION NOTICE: After turning the power switch is turned off, there may be a waiting time before disconnecting the auxiliary negative (-) battery terminal. Click here 2. CUST
SEE MORE:
Air conditioning filter
The air conditioning filter must be
changed regularly to maintain air
conditioning efficiency.
Removal method
1. Turn the power switch off.
2. Open the glove box. Slide off the
damper.
3. Push in the glove box on the vehicle's
outer side to disconnect the
claws. Then pull out the glove
Parts Location
PARTS LOCATION ILLUSTRATION *1 AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1) *2 CHARCOAL CANISTER ASSEMBLY *3 EGR VALVE ASSEMBLY *4 FUEL TANK CAP ASSEMBLY *5 HEATED OXYGEN SENSOR (for Bank 1 Sensor 2) *6 PCV VALVE *7 PURGE VSV *8 NO. 1 ENGINE ROOM RELAY BLOCK AN
© 2016-2024 Copyright www.lexunx.com
