Lexus NX: Noise Occurs or Sound Skips when Portable Player Plays
CAUTION / NOTICE / HINT
HINT:
-
Perform this check with the portable player volume set at an appropriate level.
-
Make sure that there are no obstructions between the portable player and radio receiver assembly that may block signals, and that the portable player and radio receiver assembly are not excessively far apart.
-
Make sure that devices other than the radio receiver assembly are not connected to the portable player.
-
Make sure that there is no interference from a wireless LAN, etc.
PROCEDURE
1. | CHECK USING ANOTHER "Bluetooth" AUDIO COMPATIBLE VEHICLE OF SAME MODEL |
(a) Check that the same problem does not occur in the sound heard from the speakers of another "Bluetooth" audio compatible vehicle of the same model.
OK:
The same problem does not occur in the sound heard from the speakers.
NG | | MALFUNCTION IN PORTABLE PLAYER |
OK | | |
2. | REMOVE ADDITIONAL DEVICES WHICH USE RADIO WAVES |
(a) Remove additional devices which use radio waves.
(b) Play the portable player and check that the same problem does not occur in the sound heard from the speakers.
OK:
The same problem does not occur in the sound heard from the speakers.
OK | | END |
READ NEXT:
CAUTION / NOTICE / HINT HINT: Some versions of "Bluetooth" compatible audio players may not function properly, or the functions may be limited using the radio receiver assembly, even if the portable a
PROCEDURE 1. DELETE OPERATION (a) Check if a registered portable player can be deleted normally. OK: Registered portable player can be deleted normally. OK END NG PROCEED TO
CAUTION / NOTICE / HINT HINT: Some versions of "Bluetooth" compatible audio players may not function properly, or the functions may be limited using the radio receiver assembly, even if the portable a
SEE MORE:
DESCRIPTION This DTC is stored if refrigerant pressure on the high pressure side is extremely low (176 kPa (1.8 kgf/cm2, 26 psi) or less) or extremely high (3025 kPa (30.8 kgf/cm2, 439 psi) or more). The air conditioning tube and accessory assembly (air conditioner pressure sensor), which is install
INITIALIZATION INITIALIZATION SERVO MOTOR (a) Turn the power switch off. (b) Connect the Techstream to the DLC3. (c) Turn the power switch on (IG). (d) Press the A/C OFF switch. (e) Turn the Techstream on. (f) Enter the following menus: Body Electrical / Air Conditioner / Utility / Servomotor Initia
© 2016-2025 Copyright www.lexunx.com
