REPLACEMENT PROCEDURE 1. REPLACE RING PIN NOTICE: It is not necessary to remove the ring pin unless it is being replaced. (a) Remove the 12 ring pins. (b) Using a plastic-faced hammer, install 12 new ring pins. *a Upper Side *b Lower Side *c 15 mm (0.591 in.) *d 14 mm (0.551 in.)
If a wheel is bent, cracked or heavily
corroded, it should be replaced.
Otherwise, the tire may separate
from the wheel or cause a loss of
handling control.
Wheel selection
When replacing wheels, care should
be taken to ensure that they are equivalent
to those removed in load capacity,
di