Lexus NX: Rear Light Assembly
READ NEXT:
Components
COMPONENTS ILLUSTRATION *A w/o Power Back Door System *B w/ Power Back Door System *1 BACK DOOR FINISH COVER LH *2 BACK DOOR FINISH COVER RH *3 BACK DOOR LOCK COVER *4 BA
Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure described below is for the LH side.
PROCEDURE 1. REMOVE CENTER BACK DOOR GARNISH Click here
Disassembly
DISASSEMBLY CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. REMOVE REAR LIGHT GASKET LH (a) Remove
SEE MORE:
Accumulator Pressure Sensor (C1365)
DESCRIPTION The accumulator pressure sensor is built into the brake actuator (brake booster with master cylinder assembly). The skid control ECU (brake booster with master cylinder assembly) detects the accumulator pressure from the data sent from the accumulator pressure sensor, and then starts and
Removal
REMOVAL PROCEDURE 1. PRECAUTION CAUTION: Be sure to read Precoution thoroughly before serving. Click here NOTICE: After the power switch is turned off, there may be a waiting time before disconnecting the negative (-) auxiliary battery terminal. Click here 2. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY
© 2016-2026 Copyright www.lexunx.com
