Lexus NX: Removal

REMOVAL

CAUTION / NOTICE / HINT

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT:

  • Use the same procedure for the RH and LH sides.
  • The procedure listed below is for the LH side.

PROCEDURE

1. REMOVE FRONT SEAT ASSEMBLY LH

Click here

2. REMOVE FRONT LOWER SEAT CUSHION SHIELD

Click here

3. REMOVE FRONT SEAT CUSHION SHIELD LH

Click here

4. REMOVE FRONT INNER SEAT CUSHION SHIELD LH

Click here

5. REMOVE FRONT SEAT HEADREST SUPPORT

Click here

6. REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD

Click here

7. REMOVE SEPARATE TYPE FRONT SEATBACK COVER LH

(a) Pass the 3 seatback cover brackets through the 3 holes of the separate type front seatback pad.

(b) Remove the 14 hog rings to remove the separate type front seatback cover LH from the separate type front seatback pad LH.

READ NEXT:

 Inspection

INSPECTION PROCEDURE 1. INSPECT SEPARATE TYPE FRONT SEATBACK COVER LH *a Component without harness connected (Separate Type Front Seatback Cover LH (Front Seatback Heater)) (a) Check the sepa

 Installation

INSTALLATION CAUTION / NOTICE / HINT CAUTION: Wear protective gloves. Sharp areas on the parts may injure your hands. HINT: Use the same procedure for the RH and LH sides. The procedure listed be

 Lumbar Support Adjuster Assembly

SEE MORE:

 Headlight ECU Communication Stop Mode

DESCRIPTION Detection Item Symptom Trouble Area Headlight ECU Communication Stop Mode Any of the following conditions are met: Communication stop for "Headlight swivel (AFS)" is indicated on the "Communication Bus Check" screen of the Techstream. Click here Communication system

 Removal

REMOVAL CAUTION / NOTICE / HINT NOTICE: Do not replace the spiral with sensor cable sub-assembly with the battery connected and the engine switch on (IG). Do not rotate the spiral with sensor cable sub-assembly when the following conditions are met: 1) The steering wheel is removed, 2) the batt

© 2016-2025 Copyright www.lexunx.com