Lexus NX: Seat Heater Control(for Rear Seat)
READ NEXT:
Components
COMPONENTS ILLUSTRATION *A for RH Side *B for Manual Seat *C for Power Seat - - *1 REAR SEATBACK ASSEMBLY RH *2 REAR SEATBACK BOARD CARPET ASSEMBLY RH *3 REAR SEATB
Removal
REMOVAL CAUTION / NOTICE / HINT CAUTION: Wear protective gloves. Sharp areas on the parts may injure your hands. PROCEDURE 1. REMOVE REAR SEATBACK ASSEMBLY LH (a) for Manual Seat: Click here (b) for
Installation
INSTALLATION CAUTION / NOTICE / HINT CAUTION: Wear protective gloves. Sharp areas on the parts may injure your hands. PROCEDURE 1. INSTALL SEAT HEATER CONTROL SUB-ASSEMBLY (for LH Side) (a) for Manual
SEE MORE:
Low Output Signal of Rear Speed Sensor RH (C1273,C1274,C1466,C1467)
DESCRIPTION Each speed sensor detects the wheel speed and sends the signals to the skid control ECU (brake booster with master cylinder assembly). These signals are used for ABS control. DTCs C1273 and C1274 are cleared when the speed sensor sends a wheel speed signal or when Test Mode ends. DTCs C1
Front Left Seat Heat Sensor Circuit (B14C1)
DESCRIPTION Output to the front seat cushion heater temperature sensor stops if one of the following occurs: 1) the temperature sensor is open or shorted; or 2) the temperature sensor is damaged and its output value does not change. DTC No. Detection Item DTC Detection Condition Trouble Are
© 2016-2026 Copyright www.lexunx.com
