Lexus NX: Steps to take in an emergency
Lexus NX Owners Manual / When trouble arises / Steps to take in an emergency
- If your vehicle needs to be towed
- If a warning light turns on or a warning buzzer sounds
- If a warning message is displayed
- If you have a flat tire
- If the hybrid system will not start
- If the electronic key does not operate properly
- If the 12-volt battery is discharged
- If your vehicle overheats
READ NEXT:
If your vehicle needs to be towed
If towing is necessary, we recommend
having your vehicle towed by
your Lexus dealer or commercial
towing service, using a wheel-lift
type truck or flatbed truck.
Use a safety chain system for a
If a warning light turns on or a warning
buzzer sounds
Calmly perform the following actions if any of the warning lights comes
on or
flashes. If a light comes on or flashes, but then goes off, this does not
necessarily
indicate a malfunction in the
If a warning message is displayed
The multi-information display
shows warnings of system malfunctions,
incorrectly performed operations,
and messages that indicate a
need for maintenance. When a
message is shown, perform the corr
SEE MORE:
Inspection
INSPECTION PROCEDURE 1. INSPECT INTEGRATION CONTROL AND PANEL ASSEMBLY (ABSORBER CONTROL SWITCH) (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Switch Condition Specified Condition 8 (B) - 1 (GND) Normal position ON
Oxygen (A/F) Sensor Heater Control Circuit Low (Bank 1 Sensor 1) (P0031,P0032,P101D)
DESCRIPTION Refer to DTC P2195. Click here HINT:
When any of these DTCs are stored, the ECM enters fail-safe mode. The ECM turns off the air fuel ratio sensor heater in fail-safe mode. Fail-safe mode continues until the power switch is turned off.
Although the DTC titles say oxygen sensor, th
© 2016-2025 Copyright www.lexunx.com
