Lexus NX: Stereo Component Amplifier Malfunction (B15A3)

Lexus NX Service Manual / Audio & Visual & Telematics / Audio / Video / Audio And Visual System / Stereo Component Amplifier Malfunction (B15A3)

DESCRIPTION

These DTCs are stored when a malfunction occurs in the stereo component amplifier assembly.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

B15A3

Stereo Component Amplifier Malfunction

When one of the conditions below is met:

  • Internal power supply malfunction
  • DSP error
  • EEPROM error

Stereo component amplifier assembly

PROCEDURE

1.

CHECK DTC

(a) Clear the DTCs.

Click here

Body Electrical > Navigation System > Clear DTCs

(b) Recheck for DTCs and check that no DTCs are output.

Click here

Body Electrical > Navigation System > Trouble Codes

OK:

No DTCs are output.

OK

USE SIMULATION METHOD TO CHECK

NG

REPLACE STEREO COMPONENT AMPLIFIER ASSEMBLY

READ NEXT:

 Display Malfunction (B15A6,B15B0)

DESCRIPTION These DTCs are stored when a malfunction occurs in the multi-display assembly. DTC No. Detection Item DTC Detection Condition Trouble Area B15A6 Display Malfunction When o

 Short in GPS Antenna (B15C0,B15C1)

DESCRIPTION These DTCs are stored when a malfunction occurs in the navigation antenna assembly. DTC No. Detection Item DTC Detection Condition Trouble Area B15C0 Short in GPS Antenna

 Speaker Output Short (B15C3)

DESCRIPTION This DTC is stored when a malfunction occurs in the speakers. In addition, the radio receiver assembly detects a malfunction via the stereo component amplifier assembly. DTC No. Detec

SEE MORE:

 Installation

INSTALLATION PROCEDURE 1. INSTALL MULTIPLEX TILT AND TELESCOPIC ECU (a) Attach the claw and install the multiplex tilt and telescopic ECU to the bracket. (b) Install the bolt and multiplex tilt and telescopic ECU to the electric power steering column sub-assembly. (c) Connect the connector and harne

 Inspection

INSPECTION PROCEDURE 1. INSPECT SEAT MEMORY SWITCH (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Switch Condition Specified Condition 1(MRY) - 5(E) SET switch pressed Below 1 Ω SET switch not pressed 10 kΩ o

© 2016-2025 Copyright www.lexunx.com