Lexus NX: Television Camera (for Rear)
Lexus NX Service Manual / Audio & Visual & Telematics / Park Assist / Monitoring / Television Camera (for Rear)
READ NEXT:
Components
COMPONENTS ILLUSTRATION *A w/ Woofer *B w/o Woofer *C w/o Power Back Door *D w/ Power Back Door *1 BACK DOOR CENTER GARNISH *2 BACK DOOR FINISH COVER LH *3 BACK DOO
Removal
REMOVAL PROCEDURE 1. PRECAUTION (a) w/ Parking Assist Monitor System: Click here (b) w/ Panoramic View Monitor System: Click here 2. REMOVE BACK DOOR TRIM BASE (w/ Power Back Door) Click here 3.
Installation
INSTALLATION PROCEDURE 1. INSTALL REAR TELEVISION CAMERA ASSEMBLY (a) Install the 2 screws and rear television camera assembly. (b) Connect the connector. 2. INSTALL BACK DOOR OUTSIDE GARNISH SUB-ASSE
SEE MORE:
Generator Control Module (P0A1A-658,P0A1A-791,P1C2A-155,P1CA6-156,P3133-659)
DESCRIPTION The MG ECU, which is built into the inverter with converter assembly, monitors its internal operation and will store DTCs if the system is malfunctioning. If any of the following DTCs are output, replace the inverter with converter assembly. DTC No. Detection Item DTC Detection Co
On-vehicle Inspection
ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT CAUTION: Be sure to follow the correct removal and installation procedures of the front seat cushion airbag assembly RH. HINT:
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
PROCEDURE 1. INSPECT F
© 2016-2026 Copyright www.lexunx.com
