Lexus NX: Water Pump With Motor

READ NEXT:

 Components

COMPONENTS ILLUSTRATION *1 HV WATER PUMP BRACKET SUB-ASSEMBLY *2 NO. 1 ENGINE UNDER COVER ASSEMBLY *3 NO. 2 INVERTER COOLING HOSE ASSEMBLY *4 WATER PUMP WITH MOTOR *5 NO. 2 I

 Removal

REMOVAL PROCEDURE 1. REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY Click here 2. DRAIN COOLANT (for Inverter Coolant) Click here 3. REMOVE UPPER RADIATOR SUPPORT SUB-ASSEMBLY Click here 4. DISCONNE

 Installation

INSTALLATION PROCEDURE 1. INSTALL HV WATER PUMP BRACKET SUB-ASSEMBLY (a) Temporarily install the HV water pump bracket sub-assembly to the inverter bracket with bolt A. *a Bolt A

SEE MORE:

 Removal

REMOVAL PROCEDURE 1. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY Click here 2. REMOVE REAR DECK FLOOR BOX Click here 3. REMOVE DECK FLOOR BOX LH Click here 4. PRECAUTION CAUTION: Be sure to read Precaution thoroughly before servicing. Click here NOTICE: After the power switch is turned off, there m

 Reassembly

REASSEMBLY PROCEDURE 1. INSTALL REAR BUMPER PAD HINT: When installing the rear bumper pad, heat the rear bumper cover and rear bumper pad using a heat light. Use the same procedure described for the other side. Standard: Item Temperature Rear Bumper Cover 20 to 30°C (68 to 86°F

© 2016-2025 Copyright www.lexunx.com