Lexus NX: Wheels

If a wheel is bent, cracked or heavily corroded, it should be replaced.

Otherwise, the tire may separate from the wheel or cause a loss of handling control.

Wheel selection

When replacing wheels, care should be taken to ensure that they are equivalent to those removed in load capacity, diameter, rim width and inset*.

Replacement wheels are available at your Lexus dealer.

*: Conventionally referred to as offset.

Lexus does not recommend using the following:

■When replacing wheels The wheels of your vehicle are equipped with tire pressure warning valves and transmitters that allow the tire pressure warning system to provide advance warning in the event of a loss in tire inflation pressure.

Whenever wheels are replaced, tire pressure warning valves and transmitters must be installed.

WARNING

■When replacing wheels

■Use of defective wheels prohibited Do not use cracked or deformed wheels.

Doing so could cause the tire to leak air during driving, possibly causing an accident.

NOTICE

■Replacing tire pressure warning valves and transmitters

Aluminum wheel precautions

READ NEXT:

 Air conditioning filter

The air conditioning filter must be changed regularly to maintain air conditioning efficiency. Removal method 1. Turn the power switch off. 2. Open the glove box. Slide off the damper. 3. P

 Electronic key battery

Replace the battery with a new one if it is depleted. ■When the card key battery needs to be replaced (if equipped) The battery for the card key is available only at Lexus dealers. Your Lexus d

 Checking and replacing fuses

If any of the electrical components do not operate, a fuse may have blown. If this happens, check and replace the fuses as necessary. Checking and replacing fuses 1. Turn the power switch off.

SEE MORE:

 Installation

INSTALLATION PROCEDURE 1. INSTALL REAR ENGINE OIL SEAL (a) Apply MP grease to the lip of a new rear engine oil seal. NOTICE: Do not allow foreign matter to contact the lip of the rear engine oil seal. Do not allow MP grease to contact the dust seal. (b) Using SST and a hammer, tap in the

 Drive Motor "A" Position Sensor Circuit Range / Performance (P0A40-504)

DTC SUMMARY MALFUNCTION DESCRIPTION This DTC indicates that an overvoltage in the inverter has occurred. The cause of this malfunction may be one of the following: Area Main Malfunction Description Step Inverter low-voltage circuit The connectors are not connected properly 2 Resol

© 2016-2026 Copyright www.lexunx.com