Lexus NX: 2ar-fxe (intake / Exhaust)
Lexus NX Service Manual / Engine & Hybrid System / 2ar-fxe (intake / Exhaust)
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 INVERTER RESERVOIR ASSEMBLY *2 NO. 1 ENGINE COVER SUB-ASSEMBLY *3 WIRE HARNESS - - N*m (kgf*cm, ft.*lbf): Specified torque - - ILLUSTRATION
Installation
INSTALLATION PROCEDURE 1. INSTALL NO. 2 EXHAUST MANIFOLD HEAT INSULATOR (a) Install the No. 2 exhaust manifold heat insulator with the 2 bolts. Torque: 13.5 N·m {138 kgf·cm, 10 ft·lbf} 2. INSTALL
SEE MORE:
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE NOTICE: When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored. HINT:
Disassembly
DISASSEMBLY CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. REMOVE NO. 1 MOULDING TAPE (a) Remove the No. 1 moulding tape (double-sided tape). HINT: Do not pull on the No. 1 moulding tape (double-sided
© 2016-2024 Copyright www.lexunx.com
