Lexus NX: Intake Manifold
READ NEXT:
Components
COMPONENTS ILLUSTRATION *A w/o Performance Damper *B w/ Performance Damper *1 AIR CLEANER CASE SUB-ASSEMBLY *2 AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY *3 OUTER COWL TOP PANEL
Removal
REMOVAL PROCEDURE 1. DISCHARGE FUEL SYSTEM PRESSURE Click here 2. PRECAUTION NOTICE: After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliar
Installation
INSTALLATION PROCEDURE 1. INSTALL INTAKE MANIFOLD (a) Connect the purge line hose to the intake manifold, and slide the clamp to secure the hose. HINT: Make sure the hose clamp is oriented as shown
SEE MORE:
Drive Motor "A" Inverter Voltage Sensor Circuit Low (P0D2F-266,P0D30-267)
DESCRIPTION The inverter contains a three-phase bridge circuit, which consists of 6 power transistors (IGBTs) each for the generator (MG1), motor (MG2) and rear motor (MGR). The inverter converts high-voltage direct current from the HV battery into three-phase alternating current for the generator (
Inspection
INSPECTION PROCEDURE 1. INSPECT OUTER MIRROR SWITCH ASSEMBLY (w/ Memory) (a) Check the mirror retract switch. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition 8 (MR) - 10 (E) Driving positio
© 2016-2024 Copyright www.lexunx.com
