Lexus NX: Canister
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 CANISTER PUMP MODULE *2 CHARCOAL CANISTER ASSEMBLY *3 FRONT FLOOR COVER CENTER LH *4 VENT LINE HOSE *5 AIR INLET LINE HOSE *6 PURGE LINE HOSE
Removal
REMOVAL PROCEDURE 1. REMOVE FRONT FLOOR COVER CENTER LH Click here 2. REMOVE CHARCOAL CANISTER ASSEMBLY (a) Disconnect the connector from the canister pump module. *1 Vent Line Ho
Inspection
INSPECTION PROCEDURE 1. INSPECT CHARCOAL CANISTER ASSEMBLY (a) Visually check the charcoal canister assembly for cracks or damage. If cracks or damage is found, replace the charcoal canister assemb
SEE MORE:
Installation
INSTALLATION PROCEDURE 1. INSTALL REAR TELEVISION CAMERA ASSEMBLY (a) Install the 2 screws and rear television camera assembly. (b) Connect the connector. 2. INSTALL BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY Click here 3. INSTALL BACK DOOR TRIM BOARD ASSEMBLY Click here 4. INSTALL BACK DOOR SIDE GA
Diagnosis System
DIAGNOSIS SYSTEM CHECK DLC3 (a) Check the DLC3. Click here INSPECT AUXILIARY BATTERY VOLTAGE (a) Check the auxiliary battery voltage. Standard voltage: 11 to 14 V (power switch off) If the voltage is below 11 V, recharge or replace the auxiliary battery.
© 2016-2026 Copyright www.lexunx.com
