Lexus NX: Components
Lexus NX Service Manual / Suspension / Tire Pressure Monitoring / Tire Pressure Warning Valve / Components
COMPONENTS
ILLUSTRATION
| *1 | TIRE PRESSURE WARNING VALVE AND TRANSMITTER | *2 | WASHER |
| *3 | VALVE CORE | *4 | GROMMET |
| *5 | NUT | *6 | VALVE CAP |
.png) | N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
READ NEXT:
Removal
REMOVAL PROCEDURE 1. REMOVE FRONT WHEEL Click here 2. REMOVE REAR WHEEL Click here 3. REMOVE TIRE PRESSURE WARNING VALVE AND TRANSMITTER (a) Remove the valve cap and valve core to release the air
Installation
INSTALLATION CAUTION / NOTICE / HINT NOTICE:
Always use a new grommet and valve core when installing the tire pressure warning valve and transmitter.
Check that the washer and nut are not damaged
Disposal
DISPOSAL CAUTION / NOTICE / HINT HINT: The tire pressure warning valve and transmitter is powered by a lithium battery. When disposing of the tire pressure warning valve and transmitter, remove the ba
SEE MORE:
Start Up Signal Circuit between Radio Receiver Assembly and Navigation ECU
DESCRIPTION This circuit includes the navigation ECU and radio and display receiver assembly. WIRING DIAGRAM PROCEDURE 1. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - NAVIGATION ECU) (a) Disconnect the I153 radio receiver assembly connector. (b) Disconnect the I173 navigation ECU
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE NOTICE: When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored. HINT:
© 2016-2026 Copyright www.lexunx.com
