Lexus NX: Removal
REMOVAL
PROCEDURE
1. REMOVE FRONT WHEEL
Click here .gif)
2. REMOVE REAR WHEEL
Click here
3. REMOVE TIRE PRESSURE WARNING VALVE AND TRANSMITTER
(a) Remove the valve cap and valve core to release the air from the tire.
NOTICE:
Keep the removed valve cap.
(b) After ensuring that a sufficient amount of air has been released, using an 11 mm deep socket wrench, remove the nut and washer used to secure the tire pressure warning valve and transmitter. Then drop the tire pressure warning valve and transmitter with the grommet into the tire.
HINT:
The grommet may remain attached to the rim.
| (c) After dropping the tire pressure warning valve and transmitter into the tire, disengage the bead using the shoe of a tire remover. NOTICE:
|
|
(d) Separate the upper bead.
(e) Take out the tire pressure warning valve and transmitter with the grommet from the tire and separate the lower bead.
(f) Remove the grommet from the tire pressure warning valve and transmitter.
READ NEXT:
Installation
INSTALLATION CAUTION / NOTICE / HINT NOTICE:
Always use a new grommet and valve core when installing the tire pressure warning valve and transmitter.
Check that the washer and nut are not damaged
Disposal
DISPOSAL CAUTION / NOTICE / HINT HINT: The tire pressure warning valve and transmitter is powered by a lithium battery. When disposing of the tire pressure warning valve and transmitter, remove the ba
SEE MORE:
Removal
REMOVAL PROCEDURE 1. REMOVE BACK DOOR CENTER GARNISH Click here 2. REMOVE BACK DOOR SIDE GARNISH LH Click here 3. REMOVE BACK DOOR SIDE GARNISH RH Click here 4. REMOVE BACK DOOR TRIM BASE (w/ Power Back Door) Click here 5. REMOVE PULL HANDLE (w/ Power Back Door) Click here 6. REMOVE B
Components
COMPONENTS ILLUSTRATION *1 DECK FLOOR BOX LH *2 NO. 3 DECK BOARD SUB-ASSEMBLY *3 REAR DECK FLOOR BOX *4 NEGATIVE AUXILIARY BATTERY TERMINAL N*m (kgf*cm, ft.*lbf): Specified torque - - ILLUSTRATION *1 DOOR SCUFF PLATE ASSEMBLY LH *2 FRONT DOOR OPENING TRIM
