Lexus NX: Components
COMPONENTS
ILLUSTRATION
| *1 | PARKING BRAKE ACTUATOR ASSEMBLY LH | *2 | REAR DISC BRAKE CYLINDER ASSEMBLY LH |
| *3 | O-RING | - | - |
.png) | N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
.png) | Lithium soap base glycol grease | - | - |
ILLUSTRATION
| *1 | PARKING BRAKE WIRE ASSEMBLY | - | - |
| | N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
READ NEXT:
On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT PARKING BRAKE ACTUATOR ASSEMBLY HINT: Using the Techstream to perform the Active Tests allows relays, VSVs and actuators and other items to be operated witho
Removal
REMOVAL PROCEDURE 1. RELEASE PARKING BRAKE (a) With the power switch on (IG), operate the electric parking brake switch to release the parking brake. Then turn the power switch off. HINT: If the parki
Inspection
INSPECTION PROCEDURE 1. INSPECT PARKING BRAKE ACTUATOR ASSEMBLY (a) Parking brake actuator assembly operation inspection (1) Apply voltage to the terminals of the parking brake actuator assembly an
SEE MORE:
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table.
Check each symptom by checking the suspe
Installation
INSTALLATION PROCEDURE 1. INSTALL MULTIPLEX NETWORK BODY ECU (MAIN BODY ECU) NOTICE:
Make sure that no foreign matter gets on the connecting surfaces.
Do not touch the ECU connector.
(a) Insert the multiplex network body ECU (main body ECU) up to the position where it contacts the housing si
© 2016-2025 Copyright www.lexunx.com
