Lexus NX: Components
COMPONENTS
ILLUSTRATION
| *1 | FRONT AXLE HUB BOLT LH | *2 | FRONT DISC |
| *3 | FRONT DISC BRAKE CALIPER ASSEMBLY LH | - | - |
.png) | N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
READ NEXT:
Replacement
REPLACEMENT CAUTION / NOTICE / HINT NOTICE:
When the brake pedal is first depressed after replacing the brake pads or pushing back the disc brake piston, DTC C1214 may be output. As there is no mal
Components
COMPONENTS ILLUSTRATION *A w/ AVS - - *1 REAR AXLE CARRIER SUB-ASSEMBLY LH *2 REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH *3 REAR NO. 1 SHOCK ABSORBER BRACKET LH *4 REAR N
SEE MORE:
Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE HOOD INSULATOR (a) Using a clip remover, remove the 7 clips. (b) Detach the 2 guides and remove the hood insulator. 2. REMOVE HOOD TO FRONT FENDER SEAL LH (a) Using a clip remover, detach the 2 claws and remove the hood to front fender seal LH.
Vanity Light Bulb
ReplacementREPLACEMENT CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. DISCONNECT VANITY LIGHT ASSEMBLY (a) Using a screwdriver, detach the claw and disconnect the vanity light assembly. HINT: Tape
© 2016-2025 Copyright www.lexunx.com
