Lexus NX: Diagnostic Trouble Code Chart
Lexus NX Service Manual / Vehicle Interior / Supplemental Restraint Systems / Occupant Classification System / Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
Occupant Classification System| DTC No. | Detection Item | Link |
|---|---|---|
| B1771 | Passenger Side Buckle Switch Circuit Malfunction | |
| B1780 | Front Occupant Classification Sensor LH Circuit Malfunction | |
| B1782 | Rear Occupant Classification Sensor LH Circuit Malfunction | |
| B1785 | Front Occupant Classification Sensor LH Collision Detection | |
| B1787 | Rear Occupant Classification Sensor LH Collision Detection | |
| B1790 | Center Airbag Sensor Assembly Communication Circuit Malfunction | |
| B1793 | Occupant Classification Sensor Power Supply Circuit Malfunction | |
| B1794 | Open in Occupant Classification ECU Battery Positive Line | |
| B1795 | Occupant Classification ECU Malfunction | |
| B1796 | Sleep Operation Failure of Occupant Classification ECU | |
.gif)
READ NEXT:
Passenger Side Buckle Switch Circuit Malfunction (B1771)
DESCRIPTION The front passenger side buckle switch circuit consists of the occupant detection ECU and front seat inner belt assembly RH. DTC B1771 is stored when a malfunction is detected in the front
Front Occupant Classification Sensor LH Circuit Malfunction (B1780)
DESCRIPTION The front occupant classification sensor LH circuit consists of the occupant detection ECU and front occupant classification sensor LH. DTC B1780 is stored when a malfunction is detected i
Rear Occupant Classification Sensor LH Circuit Malfunction (B1782)
DESCRIPTION The rear occupant classification sensor LH circuit consists of the occupant detection ECU and rear occupant classification sensor LH. DTC B1782 is stored when a malfunction is detected in
SEE MORE:
Installation
INSTALLATION PROCEDURE 1. INSTALL RADIO SETTING CONDENSER (a) Attach the claw to install a new terminal cover to the wire harness. NOTICE:
Make sure to hold the crimping side of the terminal when installing the wire harness to the terminal cover.
Make sure not to bend the exposed wire when
Inspection
INSPECTION PROCEDURE 1. INSPECT INTEGRATION CONTROL AND PANEL ASSEMBLY (ABSORBER CONTROL SWITCH) (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Switch Condition Specified Condition 8 (B) - 1 (GND) Normal position ON
© 2016-2024 Copyright www.lexunx.com
