Lexus NX: Door / Hatch

READ NEXT:

 Back Door

 Reassembly

REASSEMBLY CAUTION / NOTICE / HINT HINT: A bolt without a torque specification is shown in the standard bolt chart. Click here PROCEDURE 1. INSTALL CUSHION (a) Install the cushion. HINT: Use t

 Back Door Closer Ecu

SEE MORE:

 Installation

INSTALLATION PROCEDURE 1. INSTALL ENGINE WATER PUMP ASSEMBLY (a) Install a new gasket and the engine water pump assembly with the 5 bolts in the order shown in the illustration. Torque: 10 N·m {102 kgf·cm, 7 ft·lbf} 2. INSTALL V-RIBBED BELT TENSIONER ASSEMBLY (a) Using a 12 mm

 Thermostat

ComponentsCOMPONENTS ILLUSTRATION *1 THERMOSTAT *2 WATER INLET *3 GASKET - - N*m (kgf*cm, ft.*lbf): Specified torque ● Non-reusable part RemovalREMOVAL PROCEDURE 1. DRAIN ENGINE COOLANT Click here 2. DISCONNECT WATER INLET (a) Remove the 2 nuts and disconne

© 2016-2026 Copyright www.lexunx.com