Lexus NX: Dtc Check / Clear
Lexus NX Service Manual / Vehicle Interior / Door Lock / Power Door Lock Control System / Dtc Check / Clear
DTC CHECK / CLEAR
CHECK DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the power switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Main Body / Trouble Codes.
Body Electrical > Main Body > Trouble Codes(e) Check the details of the DTCs.
Click here .gif)
CLEAR DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the power switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Main Body / Trouble Codes.
Body Electrical > Main Body > Clear DTCs(e) Clear the DTCs.
READ NEXT:
Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. Th
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Power Door Lock Control System DTC No. Detection Item Link B1243 GSW Terminal Circuit Malfunction
GSW Terminal Circuit Malfunction (B1243)
DESCRIPTION If the collision door lock release function does not operate normally, or an open or short in the GSW input circuit of the main body ECU (multiplex network body ECU) is detected, DTC B1243
SEE MORE:
Installation
INSTALLATION CAUTION / NOTICE / HINT NOTICE: Make sure to use Toyota Genuine Windshield Glass Adhesive (High Modulus Type) or an equivalent high modulus adhesive. HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
A bolt without a torque speci
Removal
REMOVAL PROCEDURE 1. REMOVE REAR SEAT ASSEMBLY (a) for Manual Seat: Click here (b) for Power Seat: Click here 2. REMOVE REAR FLOOR FINISH PLATE Click here 3. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH Click here 4. REMOVE UPPER DECK TRIM SIDE BOARD RH Click here 5. REMOVE ROPE HOO
© 2016-2026 Copyright www.lexunx.com
