Lexus NX manuals

Lexus NX: Dtc Check / Clear

Lexus NX Service Manual / Audio & Visual & Telematics / Park Assist / Monitoring / Intelligent Clearance Sonar System / Dtc Check / Clear

DTC CHECK / CLEAR

CHECK DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the power switch on (IG).

(c) Turn the intelligent clearance sonar system on.

(d) Turn the Techstream on.

(e) Enter the following menus: Body Electrical / Advanced Parking Guidance/ICS/Intuitive P/A / Trouble Codes.

(f) Check for DTCs.

Click here

Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Trouble Codes

CLEAR DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the power switch on (IG).

(c) Turn the intelligent clearance sonar system on.

(d) Turn the Techstream on.

(e) Enter the following menus: Body Electrical / Advanced Parking Guidance/ICS/Intuitive P/A / Trouble Codes.

(f) Clear the DTCs.

Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Clear DTCs

READ NEXT:

 Fail-safe Chart

FAIL-SAFE CHART FAIL-SAFE FUNCTION (a) If a malfunction is detected in the intelligent clearance sonar system, the warning message "Parking Support Brake System Malfunction Visit Your Dealer" or "Park

 Data List / Active Test

DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a pa

 Diagnostic Trouble Code Chart

DIAGNOSTIC TROUBLE CODE CHART Intelligent Clearance Sonar System DTC No. Detection Item Link C1611 ECU Malfunction C1625 Open or Short in Steering Angle Sensor +B C162

SEE MORE:

 Rear Door Courtesy Switch Circuit

DESCRIPTION The fold seat control ECU receives the switch operation signal, driving condition signal and rear door open/close signal. Then the fold seat control ECU actives the rear seat according to these signals. WIRING DIAGRAM PROCEDURE 1. INSPECT REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY

 Terminals Of Ecu

TERMINALS OF ECU CHECK INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY AND MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) *1 Main Body ECU (Multiplex Network Body ECU) - - (a) Measure the voltage and check for pulses according to the value(s) in the table below. Terminal No. (Symbol) Wiring C

© 2016-2025 Copyright www.lexunx.com