Lexus NX: Front Lower Ball Joint

READ NEXT:

 Components

COMPONENTS ILLUSTRATION *1 FRONT AXLE ASSEMBLY LH *2 FRONT LOWER BALL JOINT ASSEMBLY LH *3 CLIP - - N*m (kgf*cm, ft.*lbf): Specified torque ● Non-reusable part

 On-vehicle Inspection

ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT FRONT LOWER BALL JOINT ASSEMBLY LH (a) Jack up the vehicle. (b) Move the front lower suspension arm up and down by hand and check for rattle. OK: No rattle

 Removal

REMOVAL CAUTION / NOTICE / HINT NOTICE: When the brake pedal is first depressed after replacing the brake pads or pushing back the disc brake piston, DTC C1214 may be output. As there is no malfunc

SEE MORE:

 Removal

REMOVAL PROCEDURE 1. REMOVE REAR SEAT ASSEMBLY (a) for Manual Seat: Click here (b) for Power Seat: Click here 2. REMOVE REAR FLOOR FINISH PLATE Click here 3. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH Click here 4. REMOVE UPPER DECK TRIM SIDE BOARD RH Click here 5. REMOVE ROPE HOO

 Diagnosis System

DIAGNOSIS SYSTEM CHECK DLC3 (a) Check the DLC3. Click here FUNCTION OF PASSENGER AIRBAG ON/OFF INDICATOR (a) Initial check (1) Turn the power switch on (IG). (2) The passenger airbag ON/OFF indicator comes on for approximately 4 seconds, and then goes off for approximately 2 seconds. (3) Approxim

© 2016-2025 Copyright www.lexunx.com