Lexus NX: Front Shock Absorber
READ NEXT:
Components
COMPONENTS ILLUSTRATION *A w/o AVS - - *1 FRONT FLEXIBLE HOSE *2 FRONT SHOCK ABSORBER WITH COIL SPRING *3 FRONT SPEED SENSOR LH *4 FRONT STABILIZER LINK ASSEMBLY LH *
Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
SST used when removing/installing the coil spring are shown
Inspection
INSPECTION PROCEDURE 1. INSPECT FRONT SHOCK ABSORBER ASSEMBLY LH (a) Compress and extend the shock absorber rod 4 or more times and check the operating sound and resistance. Standard: The operating s
SEE MORE:
Replacement
REPLACEMENT PROCEDURE 1. REMOVE NO. 1 ENGINE UNDER COVER Click here 2. DRAIN COOLANT (for Inverter Coolant) NOTICE: Collect the drained coolant and measure its volume to establish a benchmark. When adding coolant, make sure to add more coolant than the measured amount. (a) Remove the inverter re
Reassembly
REASSEMBLY CAUTION / NOTICE / HINT NOTICE:
When using a vise, place aluminum plates between the part and vise.
When using a vise, do not overtighten it.
PROCEDURE 1. INSTALL FRONT DRIVE SHAFT BEARING (for RH Side) (a) Using SST and a press, press in the front drive inboard joint assembly
© 2016-2026 Copyright www.lexunx.com
