Lexus NX: Heater Water Pump

READ NEXT:

 Components

COMPONENTS ILLUSTRATION *1 AIR CLEANER CAP SUB-ASSEMBLY *2 AIR CLEANER CASE SUB-ASSEMBLY *3 AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY *4 HEATER ACCESSORY ASSEMBLY *5 HEATER WAT

 Removal

REMOVAL PROCEDURE 1. DRAIN ENGINE COOLANT (for Inverter Coolant) Click here 2. REMOVE AIR CLEANER CAP SUB-ASSEMBLY Click here 3. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY Click here 4.

 Inspection

INSPECTION PROCEDURE 1. INSPECT HEATER ACCESSORY ASSEMBLY *a Component without harness connected (Heater Accessory Assembly (Heater Water Pump)) (a) Check the motor operation. (1) Apply the p

SEE MORE:

 Inspection

INSPECTION PROCEDURE 1. INSPECT BACK DOOR LOCK ASSEMBLY (w/o Power Back Door) (a) Check the operation of the door lock motor. (1) Move the back door lock assembly to the lock position. (2) Apply auxiliary battery voltage to the door lock motor assembly and check the operation of the door lock mot

 Installation

INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure described below is for the LH side. PROCEDURE 1. INSTALL REAR COMBINATION LIGHT ASSEMBLY LH (a) Attach the guide and pin to set the rear combination light assembly LH. *a

© 2016-2026 Copyright www.lexunx.com