Lexus NX: Installation
Lexus NX Service Manual / Vehicle Interior / Heating / Air Conditioning / Ptc Heater Assembly / Installation
INSTALLATION
PROCEDURE
1. INSTALL QUICK HEATER ASSEMBLY
| (a) Install the quick heater assembly with the screw. |
|
(b) Attach the clamp and connect the 2 connectors.
2. INSTALL NO. 1 AIR DUCT
Click here .gif)
3. INSTALL LOWER INSTRUMENT PANEL
Click here
READ NEXT:
Precaution
PRECAUTION PRECAUTIONS FOR REFRIGERANT HFO-1234yf (R1234yf) (a) Compatibility (1) The parts used in the refrigerant cycle, etc. of the HFO-1234yf (R1234yf) system are not compatible with the conventio
Replacement
REPLACEMENT PROCEDURE 1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM (a) Turn the power switch on (READY). (b) Operate the cooler compressor under the conditions shown below: Item Condition
SEE MORE:
Removal
REMOVAL PROCEDURE 1. DRAIN ENGINE COOLANT Click here 2. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY Click here 3. REMOVE AIR CLEANER CAP AND HOSE Click here 4. REMOVE EGR VALVE ASSEMBLY (a) Disconnect the connector from the EGR valve assembly. (b) Slide the 2 clamps and disconnect
Oxygen (A/F) Sensor Signal Stuck Lean (Bank 1 Sensor 1) (P2195,P2196)
DESCRIPTION HINT: Although the DTC titles say oxygen sensor, these DTCs relate to the air fuel ratio sensor. The air fuel ratio sensor generates voltage* that corresponds to the actual air fuel ratio. This sensor voltage is used to provide the ECM with feedback so that it can control the air fuel ra
© 2016-2025 Copyright www.lexunx.com
