Lexus NX: Installation
INSTALLATION
PROCEDURE
1. INSTALL TRIP SWITCH
| (a) Attach the 2 claws to install the trip switch. |
|
.png)
2. INSTALL NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
Click here .gif)
3. INSTALL INSTRUMENT SIDE PANEL LH
Click here
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 INNER REAR VIEW MIRROR ASSEMBLY *2 NO. 1 FORWARD RECOGNITION COVER *3 NO. 2 FORWARD RECOGNITION COVER - - N*m (kgf*cm, ft.*lbf): Specified torque
SEE MORE:
On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT WINDSHIELD WIPER MOTOR ASSEMBLY (a) for LH Side: (1) Check the stop (park) position. *1 Ceramic Dot *2 Louver Lip Edge *a 34 mm (1.3386 in.) *b 7.5 mm (0.2953 in.) (2) Operate the windshield wiper motor assembly.
Reassembly
REASSEMBLY CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. INSTALL NO. 2 MOULDING TAPE (a) When using a new rear door rear upper outside moulding LH: (1) Clean the surface of a new rear door rear upper
© 2016-2025 Copyright www.lexunx.com
