Lexus NX manuals

Lexus NX: No Sound can be Heard from Speakers

Lexus NX Service Manual / Audio & Visual & Telematics / Audio / Video / Audio And Visual System / No Sound can be Heard from Speakers

PROCEDURE

1.

CHECK AUDIO SETTINGS

(a) In sound output setting mode, set volume, fader and balance to the initial values and check that the sound is normal.

OK:

Audio system returns to normal.

HINT:

Sound quality adjustment measures vary according to the type of amplifier.

OK

END
NG

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

READ NEXT:

 Sound Quality is Bad Only when Disc is Played (Volume is Too Low)

CAUTION / NOTICE / HINT NOTICE: When replacing the radio receiver assembly, always replace it with a new one. If a radio receiver assembly which was installed to another vehicle is used, the following

 Disc cannot be Inserted or is Ejected Right After Insertion

CAUTION / NOTICE / HINT NOTICE: When replacing the radio receiver assembly, always replace it with a new one. If a radio receiver assembly which was installed to another vehicle is used, the following

 Disc cannot be Ejected

CAUTION / NOTICE / HINT NOTICE: When replacing the radio receiver assembly, always replace it with a new one. If a radio receiver assembly which was installed to another vehicle is used, the following

SEE MORE:

 Parts Location

PARTS LOCATION ILLUSTRATION *A w/o Navigation System *B w/ Navigation System *1 FRONT NO. 1 SPEAKER ASSEMBLY RH *2 FRONT NO. 2 SPEAKER ASSEMBLY RH *3 TELEPHONE MICROPHONE ASSEMBLY *4 MAP LIGHT ASSEMBLY - MANUAL (SOS) SWITCH *5 NO. 2 ENGINE ROOM RELAY BLOCK - DCM F

 Initialization

INITIALIZATION INITIALIZE SLIDING ROOF SYSTEM NOTICE: When the roof glass is adjusted or removed/installed, or the sliding roof drive gear sub-assembly is replaced, the glass position cannot be determined and the sliding roof drive gear sub-assembly must be initialized (pulse sensor initial posit

© 2016-2026 Copyright www.lexunx.com