Lexus NX: Outside Air Temperature Sensor (C1652)
DESCRIPTION
When a malfunction signal sent from the air conditioning system via CAN communication is detected by the clearance warning ECU assembly, DTC C1652 is stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1652 | Outside Air Temperature Sensor | Ambient temperature sensor malfunction | Air conditioning system |
CAUTION / NOTICE / HINT
NOTICE:
-
After the power switch is turned off, there may be a waiting time before disconnecting the negative (-) auxiliary battery terminal.
Click here
.gif)
-
When disconnecting and reconnecting the auxiliary battery
Click here
HINT:
When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.
Click here
-
After replacing an ultrasonic sensor or the clearance warning ECU assembly, perform the necessary procedures (adjustment, calibration, initialization or registration).
Click here
PROCEDURE
| 1. | CHECK FOR DTC |
(a) Using the Techstream, check for DTCs according to the prompts on the screen.
Click here
HINT:
After turning the power switch from off to on (IG), wait 13 seconds or more before checking for DTCs.
Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Trouble Codes(b) Clear the DTCs according to the screen on the Techstream.
Click here
(c) Recheck for DTCs.
Click here
HINT:
- DTC C1652 is stored when a malfunction signal sent from the air conditioning system is detected.
- If the malfunctioning part has been repaired or replaced before rechecking for DTCs, DTC C1652 will not be output again.
-
If DTC C1652 is output frequently, duplicate the conditions that cause the problem symptoms and perform the inspection again, even though the DTC was not output when rechecking for DTCs.
Click here
| Result | Proceed to |
|---|---|
| DTC C1652 is output | A |
| DTC C1652 is not output | B |
| A | .gif) | GO TO AIR CONDITIONING SYSTEM |
| B | | USE SIMULATION METHOD TO CHECK |
READ NEXT:
Vehicle Information Unmatched (C168D)
DESCRIPTION If the vehicle information stored in the main body ECU (multiplex network body ECU) which is sent via CAN communication during the clearance warning ECU assembly self-diagnosis does not ma
ENG / EHV Device (C1A40)
DESCRIPTION When a hybrid control system malfunction signal sent by the hybrid vehicle control ECU is detected by the clearance warning ECU assembly, DTC C1A40 is stored. DTC No. Detection Item
Stop Light Relay Circuit (C1A4B)
DESCRIPTION When a stop light relay circuit malfunction signal sent from the pre-collision system is detected by the clearance warning ECU assembly, DTC C1A4B is stored. DTC No. Detection Item
SEE MORE:
Seat Heater for Rear Left Seat does not Operate
DESCRIPTION When the refreshing seat switch is operated, the air conditioning amplifier assembly receives the signal via the LIN communication line, and operates the seat heater for the corresponding rear seat. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE:
If the auxiliary battery voltage is l
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspect
