Lexus NX: Parts Location

PARTS LOCATION

ILLUSTRATION

*1

IGNITION COIL ASSEMBLY

*2

ECM

*3

NO. 1 ENGINE ROOM RELAY BLOCK LH

- IGN FUSE

*4

SPARK PLUG

READ NEXT:

 System Diagram

SYSTEM DIAGRAM

 On-vehicle Inspection

ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT HINT: Perform "Inspection After Repair" after replacing an ignition coil assembly or spark plug. Click here PROCEDURE 1. PERFORM SPARK TEST (a) Check fo

 Knock Sensor

ComponentsCOMPONENTS ILLUSTRATION *1 KNOCK CONTROL SENSOR - - N*m (kgf*cm, ft.*lbf) : Specified torque - - RemovalREMOVAL PROCEDURE 1. REMOVE INTAKE MANIFOLD Click here 2

SEE MORE:

 Installation

INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. INSTALL REAR DRIVE SHAFT ASSEMBLY LH (a) Align the matchmarks on the rear drive shaft assembly LH and rear axle hub and bearing assembly,

 Internal Control Module Throttle Position Performance (P060E)

MONITOR DESCRIPTION The ECM monitors the signals received from the No. 1 throttle position sensor and stop light switch assembly. As the ECM monitors the STP signal of the stop light switch assembly and the No. 1 throttle position sensor, if these signals do not correlate, this DTC is stored. DTC

© 2016-2026 Copyright www.lexunx.com