Lexus NX: Parts Location
Lexus NX Service Manual / Engine & Hybrid System / 2ar-fxe (cooling) / Cooling Fan System / Parts Location
PARTS LOCATION
ILLUSTRATION
| *1 | COOLING FAN RELAY (FAN NO. 1) | *2 | COOLING FAN ECU |
| *3 | COOLING FAN MOTOR | *4 | CRANKSHAFT POSITION SENSOR |
| *5 | ECM | *6 | NO. 2 ENGINE ROOM RELAY BLOCK - FAN FUSE |
| *7 | NO. 2 COOLING FAN MOTOR | *8 | INSTRUMENT PANEL JUNCTION BLOCK - ECU-IG NO. 4 FUSE |
READ NEXT:
System Diagram
SYSTEM DIAGRAM
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of pr
On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT COOLING FAN SYSTEM (a) Connect the Techstream to the DLC3. (b) Turn the power switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Powe
SEE MORE:
Components
COMPONENTS ILLUSTRATION *1 BACK DOOR CENTER GARNISH *2 REAR SIDE SPOILER SUB-ASSEMBLY LH *3 REAR SIDE SPOILER SUB-ASSEMBLY RH *4 REAR SPOILER ASSEMBLY *5 HOLE PLUG - - N*m (kgf*cm, ft.*lbf): Specified torque - - ILLUSTRATION *1 CENTER STOP LIGHT ASSE
Software Incompatibility with Body Control Module "B" (U1331)
DESCRIPTION This DTC is stored when the destination information of the main body ECU (multiplex network body ECU) does not match that of the blind spot monitor sensors. DTC No. Detection Item DTC Detection Condition Trouble Area Note U1331 Software Incompatibility with Body Control
© 2016-2025 Copyright www.lexunx.com
