Lexus NX: Rear Lower Arm
READ NEXT:
Components
COMPONENTS ILLUSTRATION *A w/ AVS - - *1 REAR NO. 1 SUSPENSION ARM ASSEMBLY LH *2 REAR SHOCK ABSORBER ASSEMBLY LH *3 REAR SUSPENSION TOE ADJUST CAM SUB-ASSEMBLY *4 NO. 2
Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. REMOVE REAR WHEEL Click here 2. REMOVE REAR
Inspection
INSPECTION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. INSPECT REAR NO. 1 SUSPENSION ARM ASSEMBLY
SEE MORE:
Oxygen Sensor Circuit (Bank 1 Sensor 2) (P0136-P0139,P013A)
DESCRIPTION In order to obtain a high purification rate of the carbon monoxide (CO), hydrocarbon (HC) and nitrogen oxide (NOx) components in the exhaust gas, a TWC (Three-Way Catalytic Converter) is used. For the most efficient use of the TWC, the air fuel ratio must be precisely controlled so that
Illumination for Panel Switch does not Come on with Tail Switch ON
CAUTION / NOTICE / HINT NOTICE: When replacing the radio receiver assembly, always replace it with a new one. If a radio receiver assembly which was installed to another vehicle is used, the following may occur:
A communication malfunction DTC may be stored.
The radio receiver assembly may not
© 2016-2026 Copyright www.lexunx.com
