Lexus NX: 2ar-fxe (battery / Charging)
Lexus NX Service Manual / Power Source & Network / 2ar-fxe (battery / Charging)
READ NEXT:
Removal
REMOVAL PROCEDURE 1. PRECAUTION NOTICE: After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Click here
Installation
INSTALLATION PROCEDURE 1. INSTALL AUXILIARY BATTERY (a) Install the auxiliary battery. (b) Install the battery insulator to the auxiliary battery. (c) Install the L-shaped pipe section
SEE MORE:
Terminals Of Ecu
TERMINALS OF ECU CHECK MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY (a) Disconnect the M10 multiplex network master switch assembly connector. (b) Measure the voltage and resistance according to the value(s) in the table below. HINT: Measure the values on the wire harness side with the connector discon
Calibration
CALIBRATION DESCRIPTION (a) After replacing any VSC related components or performing wheel alignment adjustment, clear and read the sensor calibration data. Refer to the table below and then perform the necessary operation according to the part to be replaced in order to perform calibration. Part
© 2016-2024 Copyright www.lexunx.com
