Lexus NX: Auxiliary Battery
READ NEXT:
Removal
REMOVAL PROCEDURE 1. PRECAUTION NOTICE: After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Click here
Installation
INSTALLATION PROCEDURE 1. INSTALL AUXILIARY BATTERY (a) Install the auxiliary battery. (b) Install the battery insulator to the auxiliary battery. (c) Install the L-shaped pipe section
Battery Thermometer Sensor
On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE 1. INSPECT THERMISTOR ASSEMBLY (a) Disconnect the thermistor assembly connector. *a Component without harness connected (Thermis
SEE MORE:
Catalyst System Efficiency Below Threshold (Bank 1) (P0420)
MONITOR DESCRIPTION The ECM uses sensors mounted in front of and behind the Three-Way Catalytic Converter (TWC) to monitor its efficiency. The first sensor, the air fuel ratio sensor, sends pre-catalyst information to the ECM. The second sensor, the heated oxygen sensor, sends post-catalyst informat
Front Airbag Sensor (RH) (B1610)
DESCRIPTION The front airbag sensor RH consists of a diagnostic circuit and frontal deceleration sensor, etc. If the airbag ECU assembly receives signals from the frontal deceleration sensor, it determines whether the SRS should be activated. DTC B1610 is stored when a malfunction is detected in the
© 2016-2026 Copyright www.lexunx.com
