Lexus NX: Diagnosis System
Lexus NX Service Manual / Vehicle Interior / Door Lock / Power Door Lock Control System / Diagnosis System
DIAGNOSIS SYSTEM
CHECK DLC3
(a) Check the DLC3.
Click here .gif)
INSPECT AUXILIARY BATTERY VOLTAGE
(a) Measure the auxiliary battery voltage.
Standard voltage:
11 to 14 V (power switch off)
If the voltage is below 11 V, recharge or replace the auxiliary battery.
READ NEXT:
Dtc Check / Clear
DTC CHECK / CLEAR CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the power switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Main Body / Trouble
Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. Th
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Power Door Lock Control System DTC No. Detection Item Link B1243 GSW Terminal Circuit Malfunction
SEE MORE:
Steering Angle Sensor Communication Stop Mode
DESCRIPTION Detection Item Symptom Trouble Area Steering Angle Sensor Communication Stop Mode Any of the following conditions are met:
Communication stop for "Spiral cable (Steering Angle Sensor)" is indicated on the "Communication Bus Check" screen of the Techstream.
Click here
Inspection
INSPECTION PROCEDURE 1. INSPECT CRUISE CONTROL MAIN SWITCH (a) w/o Dynamic Radar Cruise Control System: (1) Measure the resistance according to the value(s) in the table below. *a Component without harness connected (Cruise Control Main Switch) - - Standard Resistance: Tester Connec
© 2016-2025 Copyright www.lexunx.com
