Lexus NX: Dtc Check / Clear
DTC CHECK / CLEAR
CHECK DTC (USING THE Techstream)
(a) Turn the power switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the power switch on (IG).
(d) Turn the Techstream on.
(e) Enter the following menus: Chassis / EMPS / Trouble Codes.
Chassis > EMPS > Trouble Codes
(f) Read the DTCs by following the display on the Techstream.
CLEAR DTC (USING THE Techstream)
(a) Turn the power switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the power switch on (IG).
(d) Turn the Techstream on.
(e) Enter the following menus: Chassis / EMPS / Trouble Codes.
Chassis > EMPS > Clear DTCs
(f) Clear the DTCs by following the display on the Techstream.
(g) Turn the power switch off.
(h) Disconnect the Techstream from the DLC3.
READ NEXT:
FREEZE FRAME DATA FREEZE FRAME DATA NOTICE:
It is difficult to show the specified values (judgment values) clearly because freeze frame data values change significantly due to differences in measur
FAIL-SAFE CHART If a problem occurs in the power steering system, the power steering assist will be stopped or the amount of power assist will be decreased to protect the system. Power Steering System
DATA LIST / ACTIVE TEST DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. Th
SEE MORE:
COMPONENTS ILLUSTRATION *1 DECK FLOOR BOX LH *2 NO. 3 DECK BOARD SUB-ASSEMBLY *3 REAR DECK FLOOR BOX *4 NEGATIVE AUXILIARY BATTERY TERMINAL N*m (kgf*cm, ft.*lbf): Specified torque - - ILLUSTRATION *1 ECU INTEGRATION BOX RH *2 GLOVE COMPARTMENT DOOR ASSEMBL
DISASSEMBLY PROCEDURE 1. REMOVE ENGINE COVER JOINT (a) Remove the 3 engine cover joints. 2. REMOVE SPARK PLUG Click here 3. REMOVE KNOCK CONTROL SENSOR Click here 4. REMOVE ENGINE COOLANT TEMPERATURE SENSOR Click here 5. REMOVE ENGINE OIL PRESSURE SWITCH ASSEMBLY Click here 6.