Lexus NX: Water Pump

READ NEXT:

 Components

COMPONENTS ILLUSTRATION *1 ENGINE WATER PUMP ASSEMBLY *2 FAN AND GENERATOR V BELT *3 RADIATOR RESERVE TANK ASSEMBLY *4 V-RIBBED BELT TENSIONER ASSEMBLY *5 WATER BY-PASSS HOSE

 On-vehicle Inspection

ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT HINT: Water Pump Construction Evaporation Port and Drain Plug: *1 Evaporation Port *2 Mechanical Seal *3 Fluid Catch Pocket *4 Drai

 Removal

REMOVAL PROCEDURE 1. DRAIN ENGINE COOLANT Click here 2. REMOVE FAN AND GENERATOR V BELT Click here 3. REMOVE RADIATOR RESERVE TANK ASSEMBLY (a) Slide the 2 clamps and disconnect the water by-pa

SEE MORE:

 Rear Door Courtesy Switch

ComponentsCOMPONENTS ILLUSTRATION *1 REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY - - N*m (kgf*cm, ft.*lbf): Specified torque - - RemovalREMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side.

 Inspection

INSPECTION PROCEDURE 1. INSPECT CYLINDER HEAD SUB-ASSEMBLY (a) Using a precision straightedge and feeler gauge, measure the warpage of the contact surfaces where the cylinder head contacts the cylinder block and manifold. *a Cylinder Head Lower Side *b Intake Manifold Side *c Exhaust

© 2016-2025 Copyright www.lexunx.com