Lexus NX: Components
Lexus NX Service Manual / Brake / Brake Control / Dynamic Control Systems / Front Speed Sensor / Components
COMPONENTS
ILLUSTRATION
| *A | w/ AVS | - | - |
| *1 | FRONT SKID CONTROL SENSOR WIRE LH | *2 | FRONT SPEED SENSOR LH |
.png) | N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *A | w/o AVS | - | - |
| *1 | FRONT SPEED SENSOR LH | - | - |
| | N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
READ NEXT:
Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the LH side and RH side.
The following procedure is for the LH side.
PROCEDURE 1. REMOVE FRONT TIRE Click here 2. REMOVE FRON
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the LH side and RH side.
The following procedure is for the LH side.
PROCEDURE 1. INSTALL FRONT SKID CONTROL SENSOR WIRE L
SEE MORE:
"No GPS signal" mark is displayed
CAUTION / NOTICE / HINT NOTICE: When replacing the radio receiver assembly, always replace it with a new one. If a radio receiver assembly which was installed to another vehicle is used, the following may occur:
A communication malfunction DTC may be stored.
The radio receiver assembly may not
Purge Valve
ComponentsCOMPONENTS ILLUSTRATION *1 PURGE VSV *2 FUEL VAPOR FEED HOSE *3 NO. 2 FUEL VAPOR FEED HOSE - - RemovalREMOVAL PROCEDURE 1. REMOVE PURGE VSV (a) Disconnect the wire harness clamp and connector from the purge VSV. (b) Slide the 2 clamps and disconnect
© 2016-2025 Copyright www.lexunx.com
